ADTRAN 1000R Series - Manual (Page 1282)

Command Reference Guide BGP Neighbor Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1282
BGP N EIGHBOR C ONFIGURATION C OMMAND S ET
To activate the BGP Neighbor Configuration mode, enter the router bgp-neighbor command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-list [in | out] on page 1283
advertisement-interval on page 1284
as-path-list [in | out] on page 1285
ebgp-multihop on page 1286
hold-timer on page 1287
local-as on page 1288
next-hop-self on page 1290
password on page 1291
prefix-list [in | out] on page 1292
remote-as on page 1293
route-map [in | out] on page 1294
send-community standard on page 1295
soft-reconfiguration inbound on page 1296
update-source on page 1297