ADTRAN 1000R Series - Manual (Page 618)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 618
channel-group mode on
Use the channel-group mode on command to add the interface to a channel-group. To remove an
interface from a channel-group, use the no version of this command.
Syntax Description
Specifies the channel-group number (1 to 6).
mode on Statically adds the interface to a channel group.
Default Values
By default, the interface is not part of a channel group.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
There can be up to six channel groups with 2-8 interfaces per group. Dynamic protocols are not yet
supported (only static). A physical interface can be a member of only one channel group.
Usage Examples
The following example adds the Ethernet 0/1 interface to channel group 1:
(config)#interface eth 0/1
(config-eth 0/1)#channel-group 1 mode on
(config-eth 0/1)#