ADTRAN 1000R Series - Manual (Page 633)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 633
port-auth port-control [auto | force-authorized | force-unauthorized]
Use the port-auth port-control command to configure the port-authorization state. Use the no form of
this command to return to the default settings.
Syntax Description
auto Enables the port-authentication process.
force-authorized Forces the port into an authorized state.
force-unauthorized Forces the port into an unauthorized state.
Default Values
By default, all ports are forced to an authorized state.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example forces Ethernet port 0/1 into an unauthorized state:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth port-control force unauthorized