Ip proxy-arp Page 819
Page 819
Command Reference Guide
Demand Interface Configuration Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
819
ip proxy-arp
Use the ip proxy-arp to enable proxy Address Resolution Protocol (ARP) on the interface. Use the no
form of this command to disable this feature.
Syntax Description
Defines the IP address for the interface in dotted decimal notation (for example,
192.22.73.101).
Specifies the subnet mask that corresponds to the listed IP address.
Default Values
By default, proxy ARP is enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Command was introduced.
Release 11.1
Command expanded to include the demand interface.
Functional Notes
In general, the principle of proxy ARP allows a router to insert its IP address in the source IP address field
of a packet (if the packet is from a host on one of its subnetworks). This allows hosts to reach devices on
other subnetworks without implementing routing or specifying a default gateway.
If proxy ARP is enabled, the AOS will respond to all proxy ARP requests with its specified MAC address
and forward packets accordingly.
Enabling proxy ARP on an interface may introduce unnecessary ARP traffic on the network.
Usage Examples
The following example enables proxy ARP on the virtual demand interface:
(config)#interface demand 1
(config-demand 1)#ip proxy-arp