ADTRAN 1000R Series User Manual
Page 456
Command Reference Guide
Global Configuration Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
456
line [console | telnet | ssh]
Use the line command to enter the line configuration for the specified console, Telnet, or secure shell
(SSH) session. Refer to the sections Line (Console) Interface Config Command Set
, Line
(Telnet) Interface Config Command Set
, and Line (SSH) Interface Config Command Set
for information on the subcommands.
Syntax Description
console
Enters the configuration mode for the DB-9 (female) CONSOLE port located on the
rear panel of the unit. Refer to the sections
Line (Console) Interface Config
Command Set
on page 816
for information on the subcommands found in that
command set.
telnet
Enters the configuration mode for Telnet session(s), allowing you to configure for
remote access. Refer to the section
Line (Telnet) Interface Config Command Set
for information on the subcommands found in that command set.
ssh
Enters the configuration mode for SSH. Refer to the section
for information on the subcommands found in
that command set.
Specifies the starting session to configure for remote access (valid range for
console: 0; valid range for Telnet and SSH: 0 to 4).
If configuring a single Telnet or SSH session, enter the session number and leave
the
Optional. Specifies the last Telnet or SSH session to configure for remote access
(valid range: 0 to 4).
For example, to configure all available Telnet sessions, enter line telnet 0 4.
Default Values
By default, the AOS line console parameters are configured as follows:
Data Rate: 9600
Data bits: 8
Stop bits: 1
Parity Bits: 0
No flow control
By default, there are no configured Telnet or SSH sessions.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.