Watlow CLS200 - Manual (Page 88)

Chapter 4: Setup CLS200 Series User’s Guide
72 Watlow Anafaze Doc.# 0600-3050-2000
How to Change a Parameter
To change a parameter, first select the appropriate menu,
then the parameter.
When you enter the setup menus, the first menu is SETUP
GLOBAL PARAMETERS. Refer to Figure 4.1 for a listing of
all top level menus and their related parameters.
1. Select the single loop display for the loop to set up.
2. Enter the three-key sequence. (See How to Access the
Setup Menus on page 71.) The first menu is displayed:
SETUP GLOBAL PARAMETERS.
3. To select the appropriate menu:
• Press NO to move from one menu to the next. The
menus wrap around; pressing
NO continuously
advances through the top level menus.
• Press YES to enter the displayed menu.
4. To select the parameter to be edited:
• Press NO to advance from one parameter to the
next. Parameters do not wrap around.
• Press YES to edit the displayed parameter.
5. To edit the parameter setting:
• Press up or down ( YES or NO) to scroll to the value
or choice you want to select.
• Press
ENTER to accept the change
- or -
press
BACK to cancel the change without saving.
6. Select another parameter and repeat from step 4, or
press
BACK to return to the top level menu.
7. Select another menu and repeat from step 3,
- or -
press
BACK to exit the setup menus.
The following sections tell more about the parameters for
each of the six top level menus. Each display illustration
contains the default value for that specific parameter. If
you have a controller with the enhanced features option,
there will be additional menus. (See Chapter 6, Enhanced
Features.)
Figure 4.1 shows the top level menus accessible from the
single loop display.