Watlow CLS200 - Manual (Page 36)

Chapter 2: Installation CLS200 Series User’s Guide
20 Watlow Anafaze Doc.# 0600-3050-2000
Installation
Installation of the Dual DAC and Serial DAC is essentially
the same. The main differences are in the dimensions and
the wiring. Follow this procedure to correctly install these
devices.
Jumpers
The output signal range of the Dual DAC and Serial DAC
modules is configured with jumpers. See
Configuring Dual
DAC Outputs on page 186 and Configuring Serial DAC
Outputs on page 188 for information on setting these jump-
ers.
Mounting
1. Select a location. The unit is designed for wall mount-
ing. Install it as close to the controller as possible.
2. Mark and drill four holes for screw mounting. Holes
accommodate #8 (4.0 mm) size screws. See Figure 2.11
for screw locations. Install the unit with the four
screws.
Figure 2.11 Dual DAC and Serial DAC
Dimensions
3.00 in
3.7 in
Electrical
connections
Electrical
connections
Dual DAC
3.00 in
3.62 in
4.7 in
Electrical
connections
Serial DAC
4.40 in 5.40 in
0.3 in
(8 mm)
(76 mm)
(91 mm)
(119 mm)
(137 mm)
(76 mm)
3.62 in
(91 mm)
(94 mm)
1.75 in
(44 mm)
(112 mm)
0.37 in
(9 mm)
0.65 in
(17 mm)
1.75 in
(44 mm)
0.65 in
(17 mm)
0.37 in
(9 mm)
0.3 in
(8 mm)
Electrical
connections
4 holes for #8 (4.0 mm)
screws or bolts
4 holes for #8 (4.0 mm)
screws or bolts