Watlow CLS200 - Manual (Page 69)

CLS200 Series User’s Guide Chapter 3: Using the CLS200
Doc.# 0600-3050-2000 Watlow Anafaze 53
Front Panel Keys
Press
YES to:
• Select a menu or parameter
• Answer YES to the flashing ? prompts
• Increase a value or choice when editing
• Stop scanning mode
Press NO to:
• Skip a menu or parameter when the prompt is blinking
• Answer
NO to the flashing ? prompts
• Decrease a value or choice when editing
• Stop scanning mode
• Perform a NO-key reset
NOTE! Pressing the NO key on power up performs a
NO-key reset. This procedure clears the RAM
and sets the controller’s parameters to their
default values. See NO-Key Reset on page
176.
Press BACK to:
• Cancel editing
• Return to a previous menu
• Switch between bar graph, single loop and job displays
• Stop scanning mode
Press ENTER to:
• Store data or a parameter choice after editing and go
to the next parameter
• Start scanning mode (if pressed twice)
YES (up)
NO
(down)
BACK
ENTER