Watlow CLS200 - Manual (Page 35)

CLS200 Series User’s Guide Chapter 2: Installation
Doc.# 0600-3050-2000 Watlow Anafaze 19
Mounting Environment
Leave enough clearance around the power supply so that it
can be removed.
Figure 2.10 CLS200 Power Supply Mounting
Bracket
Mounting Steps
CAUTION! Use 6-32, 1/4-inch screws only. Longer
screws may extend too far into the power
supply and short to components, damaging
the power supply.
1. Attach the bracket to the power supply using the
bracket’s two center holes.
2. Select a location with enough clearance to remove the
power supply and bracket. (See Figure 2.10.)
3. When a location has been determined for the power
supply, mark the bracket’s two outer holes for mount-
ing.
4. Drill and tap the two mounting holes. (The bracket
holes accept up to #10 [5.0 mm] screws.)
5. Mount the power supply on the panel.
6. Tighten the screws.
Mounting the Dual DAC or Serial DAC Module
This section describes how to install the optional Dual DAC
and Serial DAC digital-to-analog converters.
0.3 inch
(8 mm)
0.7 inch
(18 mm)
8.1 inches
(206 mm)
7.5 inches
(191 mm)
1.4 inch
(36 mm)
Two holes for #10 (5.0 mm) screws or bolts