Watlow CLS200 - Manual (Page 17)

Doc.# 0600-3050-2000 Watlow Anafaze 1
1
System Overview
Manual Contents
This manual describes how to install, set up, and operate a
CLS204, CLS208 or CLS216 controller. Each chapter cov-
ers a different aspect of your control system and may apply
to different users:
• Chapter 1: System Overview provides a component
list and summary of features for the CLS200 series
controllers.
• Chapter 2: Installation provides detailed instruc-
tions on installing the CLS200 series controller and its
peripherals.
• Chapter 3: Using the CLS200 provides an overview
of operator displays used for system monitoring and
job selection.
• Chapter 4: Setup provides detailed descriptions of
all menus and parameters for controller setup.
• Chapter 5: Extruder Control explains the addition-
al features of a CLS200 controller equipped with Ex-
truder Control Firmware.
• Chapter 6: Enhanced Features describes process
variable retransmit, ratio, differential and cascade
control features available with the enhanced features
option.
• Chapter 7: Ramp/Soak explains how to set up and
use the features of the ramp/soak option.
• Chapter 8: Tuning and Control describes available
control algorithms and provides suggestions for appli-
cations.
• Chapter 9: Troubleshooting and Reconfiguring
includes troubleshooting, upgrading and reconfigur-
ing procedures for technical personnel.