beautypg.com

System alarms, Job display – Watlow CLS200 User Manual

Page 76

background image

Chapter 3: Using the CLS200

CLS200 Series User’s Guide

60

Watlow Anafaze

Doc.# 0600-3050-2000

System Alarms

When a system alarm occurs, the global alarm output turns
on and an alarm message appears on the display. The mes-
sage continues to be displayed until the error condition is
removed and the alarm is acknowledged. The CLS200 can
display the following system alarms:

BATTERY DEAD
See Battery Dead on page 168.

LOW POWER
See Low Power on page 168.

AW
See Ambient Warning on page 168.

H/W FAILURE: AMBIENT
See H/W Ambient Failure on page 169.

H/W FAILURE: GAIN
See H/W Gain or Offset Failure on page 170.

H/W FAILURE: OFFSET
See H/W Gain or Offset Failure on page 170.

Job Display

The job display appears only if:

You have enabled JOB SELECT DIG INPUTS. (See
Load Setup From Job on page 75.)
– and –

You have selected a job from the job load menu.

After loading a job using the LOAD SETUP FROM JOB
menu, the job display shows you the following screen:

If parameters are modified while the job is running, this
screen will display:

If the job was loaded using digital inputs, the display
shows:

ALARM

JOB 3 RUNNING

ALARM

JOB 3 RUNNING
DATA MODIFIED

ALARM

JOB 3 RUNNING
REMOTELY LOADED