Watlow CLS200 - Manual (Page 163)

CLS200 Series User’s Guide Chapter 7: Ramp/Soak
Doc.# 0600-3050-2000 Watlow Anafaze 147
Table 7.5 Ramp/Soak Control Status Symbols
Time Remaining Display
From the single loop display, press the
RAMP/SOAK key
once.
This screen shows how much time remains to complete the
profile. All screens that are accessed by pressing
RAMP/
SOAK key have the same information on the top line.
Cycle Number Display
From the single loop display, press the RAMP/SOAK key
twice. This screen displays the number of times the profile
has run out of the total number of cycles. In this example,
the ramp/soak profile is on the 10th of 15 cycles to be per-
formed.
Set Mode Display
From the single loop display, press the RAMP/SOAK key
three times. The SET MODE parameter allows you to
change the ramp/soak mode.
Ramp/Soak
Symbol
Description
R A profile is unning.
H A profile is holding
S A profile is in ready stat .
O
A profile is in tole ance hold.
W
A profile is in t igger wait.
ALARM
04 A SEG10/20 R
TIM REM= 32:11
Loop Number
Profile Letter
Current Segment
Number of Segments
Ramp/Soak Mode
in Profile
Time Remaining
ALARM
04 A SEG10/20 R
CYCLE NR= 10/15
ALARM
01 A SEG01/05 R
SET MODE? START