Watlow CLS200 - Manual (Page 168)

Chapter 7: Ramp/Soak CLS200 Series User’s Guide
152 Watlow Anafaze Doc.# 0600-3050-2000
• The controller shows you the ASSIGN R/S PROFILE
screen in case you would like to assign a different pro-
file to the loop or select NONE to unassign the profile.
In Case of a Power Failure
If the power fails or the controller is otherwise powered
down while running a ramp/soak profile, by default the pro-
file is set to the START mode when power is restored.
If the POWER UP OUTPUT STATUS parameter in the SETUP
GLOBAL PARAMETERS menu is set to MEMORY, then after a
power failure the profile will resume operation at the
elapsed time of the segment that was active when the pow-
er failure occurred.