Watlow CLS200 - Manual (Page 155)

CLS200 Series User’s Guide Chapter 7: Ramp/Soak
Doc.# 0600-3050-2000 Watlow Anafaze 139
Ready Segment Edit Events
Press
YES to set or edit the ready state for all outputs that
are not used for control or for the Serial DAC clock. When
you assign a profile, the controller starts the ready seg-
ment: it goes to the setpoint and puts all the outputs in the
state you set here. The outputs stay in the states they are
set to until their states are changed at the end of subse-
quent segments.
Press NO to advance to EXTERNAL RESET INPUT NUMBER.
Ready Event Output
Press NO to increment the output number. Press YES to set
the event state to ON or OFF.
This parameter appears only if you answered
YES to READY
SEGMENT EDIT EVENTS?.
Selectable values: ON or OFF.
When you are done, press BACK to return to READY SEG-
MENT EDIT EVENTS, then press NO to go to the next pa-
rameter.
External Reset Input Number
Select one of the eight digital inputs as an external reset.
When the reset input is on, the profile is set to RUN mode at
the beginning of the first segment. As long as the reset in-
put is on, the profile is held at the beginning of the first seg-
ment. Once the reset input turns off the profile begins to
run.
Selectable values: 1 to 8, or N (for no external reset).
ALARM
A READY SEGMENT
EDIT EVENTS ?
ALARM
A READY EVENT
OUTPUT 15? OFF
ALARM
A EXTERNAL RESET
INPUT NUMBER? N