Watlow 8LS Controller User Manual
8ls user’s guide, Watlow controls
8LS
User’s Guide
Part No. 10585-00. Revision 9.2
July 1996
Watlow Controls
1241 Bundy Blvd.
Winona, MN 55987
Customer Service
Phone:
(800) 414-4299
Fax:
(800) 445-8992
Technical Support
Phone:
(507) 494-5656
Fax: (507)
452-4507
Email: [email protected]
Table of contents
Document Outline
- Cover
- Contents
- Overview
- Introduction
- Installation
- Using the 8LS
- Setup
- How to Enter the Setup Menus
- How to Edit a Menu
- Setup Global Parameters Menu
- Setup Inputs Menu
- Setup Control Menu
- Setup Output Menu
- Setup Alarms
- Alarm Types
- High Process Alarm Setpoint
- High Process Alarm Status
- High Process Alarm Output Number
- Deviation Band Alarm
- Deviation Band Alarm Status
- High Deviation Alarm Output Number
- Low Deviation Alarm Output Number
- Low Process Alarm Setpoint
- Low Process Alarm Status
- Low Process Alarm Output Number
- Alarm Deadband
- Alarm Delay
- Test I/O
- Tuning and Control
- Troubleshooting
- Appendix A: Ramp Soak
- Introduction
- Configuring Ramp/Soak
- Setting the R/S Time Base
- Editing Ramp/Soak Parameters
- Choosing a Profile to Edit
- Copying the Setup from Another Profile
- Editing the Tolerance Alarm Time
- Editing the Ready Setpoint
- Editing the Ready State Events
- Choosing an External Reset Input
- Editing a Segment
- Setting Setment Time
- Setting a Segment Setpoint
- Configuring Segment Events
- Editing Event Outputs
- Changing Event States
- Editing Segment Triggers
- Assigning an Input to a Trigger
- Changing a Trigger's True State
- Latching or Unlatching a Trigger
- Setting Segment Tolerance
- Ending a Profile
- Repeating a Profile
- Using Ramp/Soak
- Appendix B: 8LS-CP
- Appendix C: 8LS Cascade
- Glossary