Watlow CLS200 - Manual (Page 164)

Chapter 7: Ramp/Soak CLS200 Series User’s Guide
148 Watlow Anafaze Doc.# 0600-3050-2000
See Running a Profile on page 148 and Holding a Profile or
Continuing from Hold on page 150 for instructions on
changing the ramp/soak mode.
Assigning a Profile to a Loop
Use this parameter to assign a profile to a loop.
Selectable Values: A to Q or NONE
Assigning a Profile the First Time
To assign a profile to a loop that does not have a profile cur-
rently assigned:
1. In the single loop display, switch to the loop you want
to assign a profile to.
2. Press the RAMP/SOAK key. The ASSIGN R/S PRO-
FILE parameter appears.
3. Choose one of the available profiles and press ENTER
- or -
press
BACK to return to single loop display without
sending profile data to the controller.
Assigning, Changing and Unassigning a Profile
To assign a new profile to a loop that already has one assigned:
1. In the single loop display, switch to the loop in which
you want to change or unassign the profile.
2. Press the RAMP/SOAK key three times.
3. Press the
NO key. You will see the RESET PROFILE
parameter. See Resetting a Profile on page 151.
4. Press
YES then ENTER to reset the profile. You will
see the ASSIGN PROFILE parameter. See Assigning a
Profile to a Loop on page 148.
5. Choose one of the available profiles or NONE (to
unassign) and press
ENTER.
6. To return to the single loop display without changing
the profile assignments, press
BACK.
Running a Profile
When you assign a profile, it does not start running imme-
diately. Instead, the loop is in the START mode and the
ALARM
01 ASSIGN R/S
PROFILE? A