Watlow CLS200 - Manual (Page 192)

Chapter 9: Troubleshooting and Reconfiguring CLS200 Series User’s Guide
176 Watlow Anafaze Doc.# 0600-3050-2000
Software Problems
If the controller and serial communications connections
seem to be working correctly, but you are still not getting
the result you expect, consult the resources you have avail-
able for the software program you are using.
WatView, AnaWin or Anasoft
Consult the AnaWin or Anasoft User’s Guide for help with
the user interface. WatView comes with a context-sensitive
help explaining operation of the software. Context-sensi-
tive means that you can press the F1 key to get help related
to the part of the program you are using.
User-Written Software
You can request a communications specification from Wat-
low Anafaze if you want to write your own software. Wat-
low Anafaze will answer technical questions that arise
during your software development process, but does not
otherwise support user-developed or third-party software
in any way.
NO-Key Reset
Performing a NO-key reset returns all controller settings to
their defaults. All recipes are also cleared.
To perform a NO-key reset:
1. Make a record of the controller’s settings.
2. Turn off power to the unit.
3. Press and hold the NO key on the keypad.
4. Turn on power to the controller still holding the NO
key.
5. When prompted RESET WITH DEFAULTS?, release the
NO key and press the YES key.
6. If you do not see the RESET WITH DEFAULTS? prompt
or do not get a chance to press
YES, repeat the proce-
dure.
7. Restore the controller settings.
If you have a stand-alone system, there is no way to recover
your original parameters. If you have a computer-super-
vised system with AnaWin or Anasoft, a copy of your pa-
rameters can be saved to a job file.
Replacing the EPROM
Replacing the EPROM involves minor mechanical disas-
sembly and reassembly of the controller. You will need a
Phillips screwdriver and a small flathead screwdriver.