Anaf aze, Du al d ac – Watlow CLS200 User Manual
Page 203
CLS200 Series User’s Guide
Chapter 9:Troubleshooting and Reconfiguring
Doc.# 0600-3050-2000
Watlow Anafaze
187
Figure 9.8 Dual DAC
Table 9.16 Dual DAC Jumper Settings
1.
Power down the system (if the Dual DAC is already in-
stalled and wired).
2.
Ensure the DAC1 and DAC2 terminal blocks or asso-
ciated wires are labeled such that you will know which
terminal block connects to which side of the board if
the module is already installed and wired.
3.
Unplug the two terminal blocks.
4.
Depending on the installation, you may need to un-
mount the Dual DAC module before proceeding. Re-
move the four screws from the end plate on the
opposite side of the module from the terminal blocks.
Output
Type
Jumper Settings
1/2
3/4
5/6
7/8
9/10
11/12
13/14
0 to 5V
Î
(dc)
B
A
A
O
B
A
O
0 to 10V
Î
(dc)
B
A
A
O
B
O
O
4 to 20 mA
O
A
B
A
A
O
A
A = Load jumper in the “A” position, or load jumper if header has only
two pins.
B = Load jumper in the “B” position.
O = Open. Do not load jumper.
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
+5V IN
DZC IN
+10-24V IN
V OUT
I SINK
OUT COM
+5V IN
DZC IN
+10-24V IN
V OUT
I SINK
OUT COM
DAC
2
DAC
1
ANAF
AZE
DU
AL D
AC