Extron Electronics SME 100 User Guide - Manual (Page 92)

• Subnet Mask — This field is used to change the subnet mask address of the unit.
Default subnet mask address is
255.255.0.0 .
• DNS — This field is used to assign the SME 100 to the IP address of a Domain
Name System (DNS) server.
• DHCP — If Dynamic Host Configuration Protocol (DHCP) in set to On , DHCP will
enable a server (that is on the same network as the SME 100) to automatically
assign an IP address to the SME 100.
• MAC Address — This field displays the Media Access Control (MAC) address of
the unit.
• Firmware — This field displays the firmware version that is currently installed on
the unit.
• Model — This field displays the name of the unit.
• Part Number — This field displays the Extron part number of the unit.
b
Date / Time Settings panel
NOTES:
• Click the Local Date/Time button to sync the date and time settings of the
control device (such as a control PC) to the SME 100.
• After all of the necessary changes have been made to the following configuration
options in this panel, click the
Submit button to save the configuration settings.
Clicking the Cancel button or navigating to a different web page clears any
changes that were made.
• Date — Use the drop-down menus to set the month (MM), day (DD), and
year (YYYY), respectively.
• Time — Use the drop-down menus to set the hours (HH), minutes (MM), and
AM/PM, respectively.
• Zone — Use this drop-down menu to select the desired time zone.
• Daylight Saving — Use the radio buttons to select the desired daylight savings
time setting. If set to
Off , the SME 100 will not automatically update the time to
match daylight savings time.
SME 100 • Web-based Configuration Page 86