Extron Electronics SME 100 User Guide User Manual
Page 33
•
Input #N (input video signal type) — This submenu is used to select a video signal
type for the currently selected input.
N represents the selected input (1, 2, or 3).
To use this submenu:
•
Rotate either Adjust knob to select a video signal type for the currently selected
input. See the "
Available Input Video Signal Types
" section on page 30 for
information on supported video signal types.
•
Film Detect — This submenu is used to enable and disable 3:2 pulldown detection
for NTSC and 2:2 pulldown detection for PAL video sources. 3:2 pulldown and 2:2
pulldown (film mode) helps maximize image detail and sharpness for video sources that
originated from film.
When
film detect is set to On, the SME 100 recognizes signals that originated from
film and then applies video processing algorithms that optimize the conversion of video
that was made with the 3:2 or 2:2 pulldown process. This results in sharply detailed
images.
To use this submenu:
•
Rotate either Adjust knob to turn film detect on or off. The default is
Off
.
•
H Start (horizontal start) and V Start (vertical start) — This submenu is used to set
the horizontal and vertical start positions of the active video for the selected input.
To use this submenu:
•
Rotate the horizontal ([) Adjust knob to change the horizontal start pixel position
(left edge) of the active video for the selected input. The default is
128
.
•
Rotate the vertical ({) Adjust knob to change the vertical start line position
(top edge) of the active video for the selected input. The default is
128
.
•
TTLPIX (total pixels) and Phase (pixel phase) — This submenu is used to set the
total pixels and pixel phase of the active video for the selected input.
To use this submenu:
•
Rotate the horizontal ([) Adjust knob to change the width (in pixels) of the total
display area to be sampled for the selected input.
•
Rotate the vertical ({) Adjust knob to move the pixel sampling point for the selected
input. The range of settings is
0
to
31
. The default is
16
.
•
H Active (horizontal active pixels) and V Active (vertical active lines) — This
submenu is used to set the horizontal active pixels and vertical active lines of the active
video for the selected input.
To use this submenu:
•
Rotate the horizontal ([) Adjust knob to change the width (in pixels) of the active
video for the selected input.
•
Rotate the vertical ({) Adjust knob to change the height (in lines) of the active video
for the selected input.
•
EDID Input N — This submenu is used to select an EDID to apply to the selected
input.
N represents the selected input (2 or 3). This menu is used with the 15-pin HD
and DVI inputs only (inputs 2 and 3).
To use this submenu:
•
Rotate the horizontal ([) Adjust knob to change the resolution of the selected
input. The default input resolution is
1024x768
.
•
Rotate the vertical ({) Adjust knob to change the refresh rate of the selected input.
The default input refresh rate is
60
Hz
.
SME 100 • Front Panel Operation
27