Extron Electronics SME 100 User Guide User Manual
Page 38
•
Color and Tint — This submenu is used to adjust the color and tint of the active video
for the selected input.
NOTES:
•
The
color adjustment is only available for composite, S-video, and YUVi video
signal inputs.
•
The
tint adjustment is only available for composite NTSC and
S-video NTSC video signal inputs. Tint is not available for PAL video
signal inputs.
To use this submenu:
•
Rotate the horizontal ([) Adjust knob to adjust the color of the video for the
selected input. When this configuration option is set to
0
, colors appear as shades
of gray. The range of settings is
0
to
127
. The default is
64
.
•
Rotate the vertical ({) Adjust knob to adjust the tint (appearance of colors) of the
video for the selected input. The range of settings is
0
to
127
. The default is
64
.
•
Detail — This submenu is used to adjust the image sharpness and noise reduction
of the active video for the selected input. Image sharpness and noise reduction are
simultaneously increased or decreased when configuring this option.
To use this submenu:
•
Rotate either Adjust knob to increase or decrease the image sharpness and noise
reduction. The range of settings is
0
to
127
. The default is
64
.
•
Zoom — This submenu is used to increase (zoom in) or decrease (zoom out) the size of
the active video (for the selected input) while keeping the aspect ratio constant.
To use this submenu:
•
Rotate either Adjust knob to change the size (zoom percentage) of the image.
The range of settings is dependent on the output resolution. An OSD message is
displayed when the maximum zoom percentage is reached.
The default is
100
percent.
SME 100 • Front Panel Operation
32