Extron Electronics SME 100 User Guide User Manual
Page 74
b
IP Settings panel
•
Unit Name — This field displays the network name of the unit. This name can be
changed on the
page (see page 85).
•
IP Address — This field displays the IP address of the unit. The IP address can be
changed on the
page (see page 85).
•
DHCP — This field displays the Dynamic Host Configuration Protocol (DHCP)
status. DHCP can be enabled and disabled on the
page (see
page 85).
•
Gateway IP Address — This field displays the gateway IP address of the unit. The
gateway IP address can be changed on the
page (see page 85).
•
MAC Address — This field displays the Media Access Control (MAC) address.
•
Subnet Mask — This field displays the subnet mask address. The subnet mask
address can be changed on the
page (see page 85).
•
Physical Link — This field displays information on the physical link of the unit.
c
Serial Port Settings panel
•
Port — Displays the serial port number of the unit.
•
Port Type — Displays the type of serial port type on the unit.
•
Data Bits — Displays the number of data bits used for communication with the
unit. This setting can be changed on the
page (see page 103).
•
Baud Rate — Displays the baud rate that is being used for communication with
the unit. This setting can be changed on the
•
Stop Bits — Displays the number of stop bits that are being used for
communication with the unit. This setting can be changed on the
page (see page 103).
•
Parity — Displays the parity that is being used for communication with the unit.
This setting can be changed on the
page (see page 103).
•
Flow Control — Displays the flow control being used for communication with the
unit. This setting can be changed on the
page (see page 103).
d
Encoder Settings panel
•
Input Number / Type — This field displays the selected input number and the
type of input video signal. The input number can be selected on the
page (see page 77) and the type of input video signal can be selected on the
page (see page 88).
•
Video Average Bitrate — This field displays the average bit rate of the video for
the selected input.
•
Output Resolution — This field displays the video output resolution of the selected
input. The video output resolution can be changed on the
page
(see page 88).
•
Audio Average Bitrate — This field displays the average bit rate of the audio for
the selected input.
•
Stream Mode — This field displays the stream mode (video / audio or video only)
of the selected input. The stream mode can be changed on the
page (see page 88).
•
Frame Rate — This field displays the frame rate of the selected input. The frame
rate can be changed on the
page (see page 88).
SME 100 • Web-based User Interface Operation
68