Push and pull stream playback urls, Announcement protocol (sap) – Extron Electronics SME 100 User Guide User Manual
Page 166
Push and Pull Stream Playback URLs
To verify a running stream, use the templates below to place the stream into the
VLC "Open Network Stream" dialog (see step 6 of "
"
on page 158). Substitute the SME 100 IP address
for
PULL Streaming:
URL
RTSP Unicast
RTSP://
RTSP Multicast RTSP://
or
HTTP://
Table 1. Pull Stream URLs
PUSH Streaming:
Unicast (Destination IP must be set to location where stream will be played)
TS/UDP
UDP://@:DESTINATION_PORT
TS/RTP
RTP://@:DESTINATION_PORT
ES/RTP
HTTP://
Multicast (Destination IP must be multicast IP address)
TS/UDP
UDP://@
TS/RTP
RTP://@
ES/RTP
HTTP://
Table 2. Push Stream URLs
NOTES:
•
•
UDP://@:DESTINATION_PORT is typically UDP://@:60000
•
Some dependencies may apply with certain versions of VLC.
•
For ES/RTP, SAP is available in "Video only" stream mode.
Playing a Push Stream Using Stream Announcement Protocol (SAP)
In order to play a push stream, the VLC player uses SAP to identify streams on a local
network:
1.
Open VLC. From the
View
menu, select
Playlist
(see figure 107).
Figure 107.
VLC Playlist
SME 100 • Reference Information
160