Extron Electronics Under-Desk Mounting Bracket - Manual

Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
68-700-01
Rev. A
07 02
Printed in the USA
Under-Desk Mounting Bracket Installation Instructions
1 . If feet were previously installed on the bottom of the product, remove them.
2 . Remove and discard the four screws in the top of the Extron product to be mounted.
3 . Using the screws supplied in the mounting bracket kit, secure the mounting brackets to
the top of the Extron product with the slotted holes on the outside.
4 . Hold the product with the attached brackets against the underside of the table or other
furniture. Mark the location of the brackets’ slotted screw holes on the mounting
surface.
5 . Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the mounting surface at
the marked screw locations.
6 . Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4” of the screw protrudes.
7 . Align the mounting screws with the slots in the brackets and place the product against
the surface, with the screws through the bracket slots.
8 . Slide the product slightly forward or back, then tighten all four screws to secure the
product in place. See the illustration on the back side of this card.
6 x 2 S -VID EO AN D A UD IO M AT RIX
MAV 62 S-VIDEO AND AUDIO
Under Desk
Mounting Bracket
(4) Screws
Remove and discard
(4) screws from top.
Replace with supplied
screws.
Under-Desk Mounting Bracket Installation Instructions, Cont’d