Extron Electronics SME 100 User Guide User Manual
Page 154
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
Set DNS server
IP address
E X11$ DI }
Ipd
•
X11$ ]
Set the DNS server IP address.
View DNS server
IP address
E DI }
X11$ ]
View the DNS server
IP address.
Set multicast IP
address (pull stream)
E X11$ DIPM }
Dipm X11$ ]
Set pull stream multicast IP
address.
View multicast IP
address
E DIPM }
X11$ ]
View multicast IP address.
Set verbose mode
E X12@ CV }
Vrb
•
X12@ ]
Set verbose mode.
View verbose mode
E CV }
X12@ ]
View verbose mode.
Get connection listing E CC }
[# of connections]]
In verbose mode:
Icc[# of
connections]]
Displays the number of active
connections on the SME 100.
Protocol Configuration
NTP (Network Time Protocol)
Enable NTP to set
the time
E 1NTEN }
Nten1 ]
Enables the NTP service.
Disable NTP
E 0NTEN }
Nten0 ]
Disables the NTP service and
uses the control PC to set the
time.
Sync NTP now
E 2NTEN }
Nten2 ]
Syncs the NTP service now.
View NTP status
E NTEN }
X1) ]
Displays the status of the NTP
service
Set NTP server
IP address
NOTE: Though an IP address ( X11$ ) is used in the command above, a URL (web address) can be used if
necessary.
E X11$ NTIP }
Ntip X11$ ]
Set the NTP server IP address.
Set NTP server
IP address to default
E
•
NTIP }
Ntip ]
Set the NTP server IP address
to default (empty string).
View NTP server
IP address
E NTIP }
X11$ ]
View the IP address of the
NTP server.
Set NTP port map
E N[port#]PMAP }
Pmap N[port#]]
Set the NTP port.
Reset NTP port map
E N 123PMAP }
Pmap N 00123 ]
Reset the NTP port to the
default value (123).
Disable NTP port
E N 0PMAP }
Pmap N 00000 ]
Disable the NTP port.
View NTP port map
E N PMAP }
[port#]]
View the currently set NTP
port.
NOTES:
X1)
= Off (disable) and On (enable)
0 = Off or disable, 1 = On or enable
X11$
= IP address (xxx.xxx.xxx.xxx)
Factory default IP address = 192.168.254.254
Factory default DNS server IP address = 0.0.0.0
Factory default multicast IP address = 239.199.188.138
Valid multicast IP addresses = 225.0.0.0 through 239.255.255.255
X12@
= Verbose / response mode
0 through 3 (see
SME 100 • Remote Communication and Control
148