Extron Electronics SME 100 User Guide - Manual (Page 161)

Command
ASCII Command
(host to unit) Response
(unit to host)
Additional Description
Other Commands
Front panel lock (executive mode)
Enable
1X/x Exe1 ] Limited front panel adjustments
only.
Disable 0X/x Exe0 ] Full front panel adjustments
and selection.
View setting X/x X1) ] View the status of the front
panel lock (executive mode).
NOTES:
X1) = Off (disable) and On (enable) 0 = Off or disable, 1 = On or enable
Power Save Mode
Power save mode is only accessable using SIS commands. By default, power save mode is
disabled. For information on how to enable power save mode, see "
Power save mode " on
page 142.
When enabled, power save mode monitors the activity of the SME 100. Power save mode
begins when no device activity is detected for seven minutes. In power save mode, different
subsystems of the SME 100 power down, such as the front panel backlight and decoders.
The processor stays active and monitors for activity. If activity is detected, the SME 100
powers up the subsystems that were powered down.
The SME 100
does not enter power save mode when:
• A user is logged into the SME 100 (using a web browser or terminal window)
• A stream is active
• The front panel buttons are used
• SIS commands are being received
SME 100 • Remote Communication and Control 155