Extron Electronics SME 100 User Guide User Manual
Page 110
•
Baud Rate — This drop-down menu is used to set the baud rate that is used for
communication with the SME 100. The default is
9600
.
•
Stop Bits — This drop-down menu is used to set the number of stop bits that are
used for communication with the SME 100. The default is
1
.
•
Parity — This drop-down menu is used to set the parity that is used for
communication with the SME 100. The default is
None
.
•
Flow Control — This drop-down menu is used to set the flow control that is used
for communication with the SME 100. The default is
None
.
b
Network Port Settings panel
NOTES:
•
After all of the necessary changes have been made to the following configuration
options in this panel, click the
Submit
button to save the configuration settings.
Clicking the
Cancel
button or navigating to a different web page clears any
changes that were made.
•
If network port changes need to be made, contact a network administrator. By
default, the following ports are enabled. To disable a network port, click on the
icon or place a value of 0 as the port number.
•
To re-enable a port, enter the default port number or a new port number, then
click
Submit
.
•
See the "
" section on page 7 for additional information.
•
HTTP Port (TCP) — This field is used to set the HyperText Transfer Protocol port
number. The default is
80
.
•
TFTP Port (UDP) — This field is used to set the Trivial File Transfer Protocol port
number. The default is
69
.
•
HTTPS / SSL Port (TCP) — This field is used to set the secure HyperText Transfer
Protocol port number. This HyperText Transfer Protocol uses the Secure Socket
Layer. The default is
443
.
•
FTP Port (TCP) — This field is used to set the File Transfer Protocol port number.
The default is
21
.
•
Telnet Port (TCP) — This field is used to set the Telnet port number. The
default is
23
.
•
Multicast Port (UDP) — Pull streaming only and requires four port addresses. This
field is used to set the initial multicast port. When the initial port number is entered,
the second number is entered automatically. The defaults are
6000-6003
.
•
SSH Port (TCP) — This field is used to set the Secure Shell port number. The
default is
22
.
•
RTP Port (UDP) — For pull streaming only; these fields are used to set the
Real-time Transport Protocol port number(s). After the range of port numbers
have been specified, four consecutive port numbers (two ports for video and two
ports for audio) are automatically assigned to stream video and audio to each RTP
connection. The defaults are
50000-50999
.
•
SNMP Port (UDP) — This field is used to set the Simple Network Management
Protocol port number. The default is
161
.
•
RTSP Port (TCP) — This field is used to set the Real-time Streaming Protocol port
number. The default is
554
.
•
RTSP over HTTP Port (TCP) — This field is used with the SMP plugin to select
the port used to tunnel the stream when RTP/RTSP/HTTP is selected. The default
is
8080
.
SME 100 • Web-based Configuration Page
104