Sending commands using a usb connection – Extron Electronics SME 100 User Guide User Manual
Page 128
Sending commands using a USB connection
1.
Use a Mini-B USB cable to connect a control PC or other USB device to the front panel
Config port of the SME 100 (see the "
NOTE: PCs or USB devices connected to the SME 100 using the config port
require a USB driver for communication. If a PC or device is connected to the
SME 100 Config Port while DataViewer is installed, the USB driver is loaded
automatically.
2.
Open DataViewer (see "
3.
On the Communication Setup window (see figure 97):
Figure 97.
USB Communication Setup Window
a.
Select the
USB
tab.
b.
Select the SME 100 device from the USB Port drop-down menu.
c.
Click
OK
. The Communication Setup window closes.
4.
The main DataViewer window appears. Use the
Commands
field to enter SIS commands
and view the responses in the
Responses
field (see
on page 120.
NOTE: For more information on how to use DataViewer, see the help file that comes
with the program. The help file can be accessed by opening the program and pressing
the
SME 100 • Remote Communication and Control
122