beautypg.com

Creating audio breakaway inputs, Eakaway inputs, see the, Creating audio – Extron Electronics SME 100 User Guide User Manual

Page 87: Breakaway inputs

background image

g

Input Sampling panel
To adjust the following picture adjustments, enter the desired value directly into the field
or use the

or

icons to adjust the values by

±1

.

Horizontal Start — This field is used to set the horizontal start position of the
active video for the selected input. The default is

128

.

Vertical Start — This field is used to set the vertical start position of the active
video for the selected input. The default is

128

.

Pixel Phase — This field is used to set the pixel phase of the active video for the
selected input. The range of settings is

0

to

31

. The default is

16

.

Total Pixels — This field is used to set the total pixels of the active video for the
selected input.

Active Pixels — This field is used to set the horizontal active pixels of the active
video for the selected input.

Active Lines — This field is used to set the vertical active lines of the active video
for the selected input.

h

Presets panel — User Presets
For information on saving, recalling, and renaming user presets, see the
"

User and Input Presets

" section on page 82. The currently active preset is shown

under the

Preset

drop-down box.

i

Presets panel — Input Presets
For information on saving, recalling, and renaming input presets, see the
"

User and Input Presets

" section on page 82.

Creating Audio Breakaway Inputs

To create an audio breakaway input (method 1):

1.

Start by choosing an input using the

input selection buttons

(see page 79; make sure

both the

Video

and

Audio

check boxes are selected initially). The chosen input should

be streaming the

audio data to be played over another input stream.

2.

Select the

Video

check box and deselect the

Audio

check box.

3.

Select the input that contains the video requiring an audio breakaway input.

Do not

select the same input that was selected in step 1.

4.

The input selection button selected in step 1 should now be flashing which indicates
that the audio data from this input is being used with the video of the input selected in
step 3 (this input is represented with a solid colored input selection button).

To create an audio breakaway input (method 2):

1.

Start by choosing an input using the input selection buttons (make sure both the

Video

and

Audio

check boxes are selected initially). The chosen input should be streaming the

video data that requires audio from another input stream.

2.

Check the

Audio

box and uncheck the

Video

box.

3.

Select the input (see

input selection buttons

on page 79) that contains the audio

requiring an audio breakaway.

Do not select the same input that was selected in step 1.

4.

The input selection button selected in step 3 should now be flashing which indicates
that the audio data from this input is being used with the video of the input selected in
step 1 (this input is represented with a solid colored input selection button).

SME 100 • Web-based User Interface Operation

81