Extron Electronics SME 100 User Guide - Manual (Page 49)

Comm Settings Menu
View Comm Settings
The View Comm Settings menu is used to view the current communication port settings.
Figure 23 and the information that follows, provides an overview of the submenus available.
Menu
VIEW COMM
SETTINGS
Next SERIAL PORT
9600 RS232
Next MAC ADDRESS
0005A605BEC3
Next DHCP MODE
OFF
Next I 192.168.
P 254.254
Next S 255.255.
M 000.000
Next G 000.000.
M 000.000
Next
MAC Address
View Media Access
Code (MAC)
hardware address. Serial Port
View the baud rate
and port protocol
of the unit. DHCP Mode
View the Dynamic Host
Configuration Protocol
(DHCP) On/Off status.
Gateway Address
View the gateway address
of the unit.
ADVANCED
CONFIG
Subnet Mask
View the subnet mask
of the unit. IP Address
View the IP address
of the unit.
Figure 23. View Comm Settings Submenu Overview
• Serial Port — This submenu is used to view the baud rate and port protocol.
• MAC Address — This submenu is used to view the Media Access Code (MAC)
hardware address.
• DHCP Mode — This submenu is used to view the Dynamic Host Configuration
Protocol (DHCP) status (on or off).
• IP (IP address) — This submenu is used to view the IP address.
• SM (subnet mask) — This submenu is used to view the subnet mask.
• GM (gateway address) — This submenu is used to view the gateway address.
Edit Comm Settings Menu (Hidden)
This section details how to configure the network settings of the SME 100 using the front
panel. Use the following procedure while referring to the illustrations provided and the
"
Front Panel Features " section on page 11 to configure the network settings of the
SME 100.
NOTE: For information on using the front panel for general device configuration, see the
" Front Panel Operation " section on page 22.
Menu
PRESETS
INPUT
CONFIG
PICTURE
CONTROL
ENCODER
CONFIG
STREAM
CONFIG
ADVANCED
CONFIG
VIEW COMM
SETTINGS
EDIT COMM
SETTINGS
Menu Menu Menu
Menu EXIT MENU?
PRESS NEXT
Menu Input 3
+
Next
Menu Menu
Figure 24. SME 100 Primary Configuration Menus
1. Ensure that the SME 100 is properly connected and powered on before proceeding
(see the "
Hardware Setup Overview " section on page 17).
2. Press the Menu button repeatedly until the View Comm Settings menu is shown on
the LCD display (see figure 24).
SME 100 • Front Panel Operation 43