Creating a custom edid, Eating a custom edid, see the, Creating a – Extron Electronics SME 100 User Guide User Manual
Page 113: Custom edid
Creating a Custom EDID
Use the following procedure to create a custom EDID using the Advanced Settings page on
the SME 100 (see figure 82).
Figure 82.
Advanced Settings Page — Creating a Custom EDID
1.
Connect a video output device to the 15-pin HD buffered loop connector (buffered
input 2) or the DVI buffered loop connector (buffered input 3) located on the rear panel
of the SME 100 (see the "
" section on page 12).
2.
Use the
Select Input
radio buttons to select the desired input (buffered input 2 or
buffered input 3) to capture EDID from.
3.
From the
Resolution
drop-down menu, select a custom EDID number to store the
new display EDID.
NOTES:
•
Custom 1, 2, and 3 capture EDID from the 15-pin HD buffered loop connector.
Custom 4, 5, and 6 capture EDID from the DVI buffered loop connector.
•
The new EDID will overwrite existing custom EDID information.
•
If a custom EDID is not captured, the resolution and refresh rate defaults to
1024x768 @ 60 Hz.
4.
Click the
Save Current EDID
button to store the EDID to the custom location.
SME 100 • Web-based Configuration Page
107