Extron Electronics SME 100 User Guide User Manual
Page 127
Sending commands using an RS-232 connection
1.
Use an RS-232 cable to connect a control PC or other RS-232 device to the RS-232
connector located on the rear panel of the SME 100 (see the "
section on page 12).
2.
Open DataViewer (see the "
" section on page 119).
3.
On the Communication Setup window (see figure 96):
3a
3b
3c
Figure 96.
RS-232 Connection Setup Window
a.
Select the
RS-232
tab.
b.
Select values for the following fields.
•
Com Port
(default =
COM1
)
•
Baud Rate
(default =
9600
)
•
Parity Bit
(default =
None
)
•
Data Bit
(default =
8
)
•
Stop Bit
(default =
1
)
•
Handshake
(default =
None
)
NOTE:
COM1
is the default serial port. Communication can be established with
any unused Com Port by selecting the port from the drop-down menu.
c.
Click
OK
. The Communication Setup window closes.
4.
The main DataViewer window appears. Use the
Commands
field to enter SIS commands
and view the responses in the
Responses
field (see
on page 120).
SME 100 • Remote Communication and Control
121
- AVTrac Corner Cut Solution (2 pages)
- AVTrac Demonstration Kit (2 pages)
- AVTRac End Ramp and Cable Pass-Through Kits (1 page)
- AVTrac Extension Kit (15 pages)
- 1U and 2U Rack Plate (1 page)
- Under-Desk Mounting Bracket (1 page)
- AAP Wiring Guide 68-1054-01 (1 page)
- AAP Wiring Guide 68-1052-01 (1 page)
- AAP Wiring Guide (XLR connectors) (1 page)
- AAP 314 (1 page)
- AAP 301 (1 page)
- AAP Wiring Guide 68-1055-01 (1 page)
- AAP Wiring Guide 68-1058-01 (1 page)
- AAP Wiring Guide 68-1059-01 (1 page)
- AAP-MAAP Rev. A (1 page)
- AAP-MAAP Rev. D (1 page)
- MD Floor Box AAP Bracket Kit AAP 100 MD (1 page)
- AC 100 Power Module Series (1 page)
- AAP 103 Extron Ackerman AKM UK Faceplate Kit (1 page)
- ACMP 100 (2 pages)
- Active Audio AAP (1 page)
- AKM UK Series (4 pages)
- Audio AAP Wiring Guide (1 page)
- Audio Connector Rev. A (2 pages)
- Audio Connector Rev. G (1 page)
- AVTrac Extra Channel Kit (2 pages)
- AVTrac Raceway Transition (2 pages)
- AVTrac Retrofit Transition Adapter (2 pages)
- AVTrac Trim Ring-Rough-in Adapter (2 pages)
- AVTrac Above Floor (1 page)
- BB 1 (2 pages)
- BB 1000M (2 pages)
- BB 700M (2 pages)
- BB 710M (2 pages)
- Blank Rack Panel (1 page)
- BNC to 15-Pin HD (1 page)
- BNC-5 RC Termination (1 page)
- Cable Cubby 1200 (6 pages)
- Cable Cubby 200 (18 pages)
- Cable Cubby 300C (27 pages)
- Cable Cubby 500 (6 pages)
- Flexible Conduit Kit (2 pages)
- Cable Cubby Lid and Trim Ring Replacement Kit (for 300C, 300S, 600, 800) (1 page)
- Cable Cubby Setup Guide (4 pages)
- Cable Cubby Single Space AAP Bracket Kit (1 page)