Advanced config menu – Extron Electronics SME 100 User Guide User Manual
Page 42
Advanced Config Menu
The
Advanced Config
menu is used to configure various settings (auto memory,
auto-image™, aspect ratio, OSD label), enable test patterns, and reset the SME 100.
Figure 21 and the information that follows provides an overview of the submenus and the
options that are available.
Menu
ADVANCED
CONFIG
Next
AUTO MEMORY
OFF
Next
AUTO IMAGE
IN#N ON
Next
ASPECT RATIO
IN#N FILL
Next
OSD LABEL
2 SEC
Next
TEST PATTERN
OFF
Next
RESET
NONE
Next
ADVANCED
CONFIG
Test Pattern
Select a test
pattern to assist
with configuration.
OSD Label
Select the length
of time that the OSD
label is displayed.
Reset
Reboots
the unit.
Aspect Ratio
Select the aspect
ratio of the input
video to be output
on a display.
Auto Image
Turn auto
image on or off.
Auto Memory
Turn auto
memory on or off.
Figure 21.
Advanced Config Submenu Overview
•
Auto Memory — This submenu is used to turn the auto memory feature on or off.
This configuration option is applied to all of the streams (inputs) on the SME 100. See
the "
" section on page 38 for information on
this feature.
To use this submenu:
•
Rotate either Adjust knob to turn auto memory on or off. The default is
On
.
•
Auto Image — This submenu is used to turn the auto-image feature on or off for the
currently selected input. See the "
" section on
page 40 for information on this feature.
To use this submenu:
•
Rotate either Adjust knob to turn auto-image on or off. The default is
Off
.
NOTE: A one-time auto-image can also be activated by selecting and holding
the desired front panel input button (see the "
" section on
page 11) for approximately two seconds. The one-time auto-image method does
not affect the setting of the
Auto Image
submenu.
•
Aspect Ratio — This submenu is used to set the aspect ratio of the output video for
the currently selected input. See the "
About the Aspect Ratio Submenu
page 41 for information on this feature.
To use this submenu:
•
Rotate either Adjust knob to select the desired aspect ratio (
Fill
or
Follow
). The
default is
Fill
.
SME 100 • Front Panel Operation
36