Extron Electronics SME 100 User Guide - Manual (Page 102)

Using Encoding Presets
The Encoding Presets panel is used to recall and save presets. Saving a preset saves the
current set of encoding parameters for the current output stream. Recalling a preset recalls
and applies a saved preset to the current output stream. Encoding presets allow the user to
quickly switch between various encoder profiles based on the target resolution or bit rate.
Sixteen available encoding presets are used to recall or save settings. The table below details
the settings that are saved and recalled in an encoding preset.
Encode Preset - Saved Settings
Video Resolution Profile Type Preset Name
Video Bitrate Profile Level Stream Mode
Frame Rate GOP Length Closed Caption
Bitrate Control Audio Bitrate Audio Delay
NOTE: The first several encoding presets are predefined.
#
Preset
Name Preset
Description Video
Resolution Video
Bit Rate Frame
Rate Stream
Type GOP
Length Audio
Bit Rate
1
HVGA
high 480x320 mobile,
high quality
480x320 2000 30 CBR 15 384 kbps
2
HVGA
medium 480x320 mobile,
medium quality
480x320 1000 30 CBR 25 256 kbps
3
HVGA
low 480x320 mobile,
low quality
480x320 500 25 VBR 30 128 kbps
4
VGA
high 680x480 Internet,
high quality
680x480 3000 30 CBR 15 384 kbps
5
VGA
medium 680x480 Internet,
medium quality
680x480 1500 30 CBR 25 256 kbps
6
VGA
low 680x480 Internet,
low quality
680x480 750 20 VBR 30 128 kbps
7*
720p
high 720p IPTV,
high quality
1280x720 4500 30 CBR 15 384 kbps
8*
720p
medium 720p IPTV,
medium quality
1280x720 3000 30 CBR 25 256 kbps
9*
720p
low 720p IPTV,
low quality
1280x720 1500 20 VBR 30 128 kbps
NOTE: * designates HD formats available on the SME 100 HD only.
To recall an encoding preset
1. Select the desired preset from the Preset drop-down menu (see item g in figure 73 on
page 88 ).
2. Click the Recall button to recall the selected preset.
NOTE: The preset is not recalled if the Recall button is not clicked.
To save an encoding preset
1. Select the desired parameters in the Encoder Configuration panel (see item c in figure 73
on page 88) .
2. The current preset displays None . If desired, a preset from the Preset drop-down menu
can be selected but should be recalled first to make it the current preset.
3. Select the new preset from the drop-down menu (see item g in figure 73 on page 88) .
Click the Save button to save the current parameters to the selected preset.
SME 100 • Web-based Configuration Page 96