Extron Electronics SME 100 User Guide - Manual (Page 41)

Stream Config Menu
The Stream Config menu is used to configure how the SME 100 streams to an output
device. The SME 100 operates in "push" or "pull" mode depending on the stream method
selected. Figure 20 and the information that follows provides an overview of the submenus
and the options that are available.
Menu
STREAM
CONFIG
Next
STRM METHOD Next
UNI RTSP,
MULTI RTSP.
STRM SELECT
RTSP for “Pull”,
Stream for “Push”.
STRM CONTROL
ENABLE to start stream,
DISABLE to stop.
STRM METHOD
Next Next
Next
UNI TS/UDP,
UNI TS/RTD,
UNI ES/RTP, MUL TS/UDP,
MUL TS/RTP,
MUL ES/RTP.
STREAM
Next
Select Octet Adjust Value
239.199
188.138
DEST
I P MULTICAST
Select Octet Adjust Value
192.168
254.200
DEST
I P UNICAST
ENCODER
CONFIG
STRM METHOD
STRM METHOD Next
UNI RTSP,
MULTI RTSP.
UNI TS/UDP,
UNI TS/RTD,
UNI ES/RTP, MUL TS/UDP,
MUL TS/RTP,
MUL ES/RTP.
Select Octet Adjust Value
239.199
188.138
MULT
I P MULTICAST
UNICAST
MULTICAST
STREAM
STRM SELECT
Next
RTSP for “Pull”,
Stream for “Push”.
RTSP RTSP
Next
Next
Next
UNICAST
MULTICAST
UNICAST
Figure 20. Stream Config Submenu Overview
• Stream Select — This submenu is used to configure the stream.
To use this submenu:
• Rotate either adjust knob to select RTSP to configure the pull stream or STREAM to
configure the push stream. The next menu changes depending on the selection.
The default is
RTSP .
• Stream Control (STREAM only) — This submenu enables the stream to begin
pushing audio and video to the selected destination.
• Stream Method — This submenu changes depending on the previous selections.
When pulling a stream via RTSP, choose unicast to allow each user to select the stream
or multicast to broadcast the stream to the network.
• Multi or Dest IP (IP address) — This submenu changes depending on whether
the stream config is using the
Multi or Uni stream method and is used to set the
broadcast IP address. This is the IP address that other devices will use to connect to
the streams being sent by the SME 100.
NOTES:
• This submenu is skipped when using the unicast RTP streaming protocol.
• For an overview on using multicast IP addresses, see the
"
Multicast Streaming Method — An Overview " section on page 20.
To use this submenu:
• Rotate the horizontal ([) Adjust knob to select the desired octet.
• Rotate the vertical ({) Adjust knob to adjust the value of the selected octet.
SME 100 • Front Panel Operation 35