Extron Electronics SME 100 User Guide User Manual
Page 117
4.
In the Sync to Matrix panel, select
Enabled
from the
Enabled/Disabled radio
buttons
(see figure 86).
4
5
6
7
8
9
EDID
Sync-To-Matrix
Advanced Settings
Figure 86.
Advanced Settings Page — Sync-To-Matrix
5.
Use the
Video Out
field to enter the number of the matrix switcher video output port
connected to the SME 100.
6.
Use the
IP Address
field to enter the IP address of the matrix switcher connected to
the SME 100.
7.
Use the
Telnet Port
field to enter the Telnet port of the matrix switcher connected to
the SME 100. The default is
23
.
8.
If a password is needed to access the matrix switcher connected to the SME 100, use
the
Password
(if req.)
field to enter the password.
9.
Click the
Submit
button to save the configuration settings and sync the SME 100 to the
matrix switcher.
NOTES:
•
If the SME 100 successfully syncs with the matrix switcher, the
Status
field will
display
Connected
.
•
If the
Status
field continues to display
Not Connected
, check the settings of
the matrix switcher and the SME 100 and try resyncing the devices.
SME 100 • Web-based Configuration Page
111
- AVTrac Corner Cut Solution (2 pages)
- AVTrac Demonstration Kit (2 pages)
- AVTRac End Ramp and Cable Pass-Through Kits (1 page)
- AVTrac Extension Kit (15 pages)
- 1U and 2U Rack Plate (1 page)
- Under-Desk Mounting Bracket (1 page)
- AAP Wiring Guide 68-1054-01 (1 page)
- AAP Wiring Guide 68-1052-01 (1 page)
- AAP Wiring Guide (XLR connectors) (1 page)
- AAP 314 (1 page)
- AAP 301 (1 page)
- AAP Wiring Guide 68-1055-01 (1 page)
- AAP Wiring Guide 68-1058-01 (1 page)
- AAP Wiring Guide 68-1059-01 (1 page)
- AAP-MAAP Rev. A (1 page)
- AAP-MAAP Rev. D (1 page)
- MD Floor Box AAP Bracket Kit AAP 100 MD (1 page)
- AC 100 Power Module Series (1 page)
- AAP 103 Extron Ackerman AKM UK Faceplate Kit (1 page)
- ACMP 100 (2 pages)
- Active Audio AAP (1 page)
- AKM UK Series (4 pages)
- Audio AAP Wiring Guide (1 page)
- Audio Connector Rev. A (2 pages)
- Audio Connector Rev. G (1 page)
- AVTrac Extra Channel Kit (2 pages)
- AVTrac Raceway Transition (2 pages)
- AVTrac Retrofit Transition Adapter (2 pages)
- AVTrac Trim Ring-Rough-in Adapter (2 pages)
- AVTrac Above Floor (1 page)
- BB 1 (2 pages)
- BB 1000M (2 pages)
- BB 700M (2 pages)
- BB 710M (2 pages)
- Blank Rack Panel (1 page)
- BNC to 15-Pin HD (1 page)
- BNC-5 RC Termination (1 page)
- Cable Cubby 1200 (6 pages)
- Cable Cubby 200 (18 pages)
- Cable Cubby 300C (27 pages)
- Cable Cubby 500 (6 pages)
- Flexible Conduit Kit (2 pages)
- Cable Cubby Lid and Trim Ring Replacement Kit (for 300C, 300S, 600, 800) (1 page)
- Cable Cubby Setup Guide (4 pages)
- Cable Cubby Single Space AAP Bracket Kit (1 page)