Extron Electronics SME 100 User Guide - Manual (Page 44)

About the Auto Memory Submenu
NOTE: For information on using the web-based user interface to enable or disable the
auto memory feature, see the " Encoder Settings Page " section on page 88.
When the Auto Memory submenu is set to On (default), the SME 100 stores the picture
settings of the incoming signal that is connected to each input. When the same input
signal is detected again, the stored picture settings are recalled from memory and are
automatically applied to the appropriate input.
The table below details the picture settings that are saved when the auto memory feature is
enabled.
Auto Memory Saved Settings
Primary Menu
Saved Settings
Input Config
Film Detect Pixel Phase
Horizontal Start Horizontal Active Pixels
Vertical Start Vertical Active Lines
Total Pixels
Picture Control
Horizontal Position Contrast
Vertical Position Color
Horizontal Size Tint
Vertical Size Detail
Brightness Zoom
When the Auto Memory submenu is set to Off , the SME 100 will treat every applied input
as a new source. Input presets can be used in place of using the auto memory feature if
desired.
NOTE: For information on using input presets, see the " Using User and Input
Presets " section on page 82 or see " Presets " on page 140 of the " Command and
Response Table for SIS Commands " section.
SME 100 • Front Panel Operation 38