beautypg.com

Streaming presets, Input config menu – Extron Electronics SME 100 User Guide User Manual

Page 32

background image

Streaming Presets

NOTES:

For information on recalling and saving streaming presets using the
web-based user interface, see the "

Using Streaming Presets

" section on page 97.

For information on recalling and saving streaming presets using
SIS commands, see "

Streaming presets

" on page 140 of the "

Command and

Response Table for SIS Commands

" section.

Streaming presets are used in the push configuration only.

Streaming presets are used when a shortcut is needed to quickly recall a group of changes
in the streaming configuration on the SME 100.

Streaming Preset Saved Settings
SAP Settings
Stream Method (MPEG-TS)

MTU

IP (Multicast or Destination)

QoS

Destination Port

TTL

The

Stream Rcall

and

Stream Save

menus shown in

figure 16

on page 23 are used to

recall and save streaming presets. The

Stream Save

menu creates presets by saving the

current set of streaming parameters for the current output stream. The

Stream Rcall

menu

recalls and applies a saved preset to the current output stream.

Sixteen available streaming

presets are used to recall or save settings.

Input Config Menu

The

Input Config

menu is used to select and configure a video signal type for the currently

selected input. Figure 17 and the information that follows provide an overview of the
submenus and the options that are available.

PRESETS

Menu

INPUT

CONFIG

Next

INPUT #N

YUVp/YUV–HD

Next

FILM DETECT

IN#N

Next

H START V

0128 0128

Next

TTLPIX PHASE

0858 016

Next

H

ACTIVE V

0720 0483

Next

EDID INPUT N

1024x768@60

Next

Film Detect
Turn film
detection on
or off for the
selected input.

Input Video Signal Type
Select an available video
signal type. Each input (N)
supports different video
signal types.

Horizontal Start
Select a horizontal
start pixel position
for the left edge of
the active video.

Vertical Start
Select a vertical
start line position
for the top edge of
the active video.

Total Pixels
Specify the width
in pixels of the
total image area
to be sampled.

Pixel Phase
Adjust the pixel
sampling point.

Horizontal Active
Specify the width
in pixels of the
active image area
to be sampled.

Vertical Active
Specify the height
in lines of the
active image area
to be sampled.

Input Resolution
Select the input
resolution. This
menu is used with
inputs (

N) 2 and 3.

Refresh Rate
Select the rate:

50 Hz

60 Hz

Figure 17.

Input Config Submenu Overview

SME 100 • Front Panel Operation

26