Extron Electronics SME 100 User Guide User Manual
Page 50
3.
Press and hold the Next button and the Input 3 button simultaneously for approximately
three seconds. This changes the
View Comm Settings
menu to the
Edit Comm
Settings
menu.
4.
Press the Next button repeatedly to cycle to the IP address (
IP
), subnet mask (
SM
), and
default gateway (
GM
) submenus (see figure 25).
Next
Next
Next
Next
Next
+
Input 3
Next
Next
EDIT COMM
SETTINGS
DHCP MODE
SERIAL PORT
9600 RS232
I
P
VIEW COMM
SETTINGS
Change Value
Valid addresses
are 0 – 254.
DHCP Mode
Turn DHCP
on or off.
Select
Octet
S
M
G 000.000.
M 000.000
Change Value
Valid addresses
are 0 – 255.
Select
Octet
Change Value
Valid addresses
are 0 – 254.
Select
Octet
255.255.
000.000
192.168.
254.254
Baud Rates
300 600
1200 1800,
2400 4800 9600 (default),
19200 38400 57600 115200
Figure 25.
Edit Comm Settings Submenus
5.
Change the IP address, subnet mask, and default gateway as necessary. To configure
the addresses:
•
Cycle to the desired octet by rotating the left Adjust knob (
[
).
•
Adjust the value of the octet by rotating the right Adjust knob (
{
).
6.
Save the network settings by pressing the Menu button. The network settings of the
SME 100 are now configured.
After the network settings have been saved, the SME 100 can be further configured using
the following methods:
•
Front panel configuration — For information on configuring the SME 100 using the
front panel, see the "
•
Web-based user interface configuration — For information on configuring the
SME 100 using the web-based user interface, see the "
" section on page 46.
SME 100 • Front Panel Operation
44