Extron Electronics SME 100 User Guide - Manual (Page 103)

Renaming an encoding preset
1. Select the desired encoding preset from the Preset drop-down menu .
2. Rename the encoding preset using the Rename Preset field (16 characters maximum).
3. Click the Rename button to save the encoding preset name. Click the Cancel button or
navigate to a different web page to clear any changes that were made.
Using Streaming Presets
The Streaming Presets panel is used to recall and save presets. Saving a preset saves the
current set of encoding or streaming parameters for the current output stream. Recalling a
preset recalls and applies a saved preset to the current output stream. Streaming presets
allow the user to quickly switch between various streaming profiles based on the target
resolution or bit rates. Sixteen available streaming presets are used to recall or save settings.
The table below details the settings saved and recalled in a streaming preset.
Streaming Presets - Saved Settings
SAP Control
(includes all SAP settings)
Stream Method (MPEG-TS)
MTU
IP (multicast or destination) QoS
Destination Port TTL
Saving or recalling a streaming preset
1. Select the desired streaming preset from the Preset drop-down menu (see item h in
figure 73 on page 88) .
2. Click the Recall button to make selection the current streaming preset. Click the Save
button to save the current streaming parameters to the selected streaming preset.
NOTE: The streaming preset is not saved or recalled if the Save or Recall button is
not clicked.
Renaming a streaming preset
1. Select the desired streaming preset from the Preset drop-down menu (see item h in
figure 73 on page 88) .
2. Rename the streaming preset using the Rename Preset field (16 characters maximum).
3. Click the Rename button to save the streaming preset name. Click the Cancel button or
navigate to a different web page to clear any changes that were made.
SME 100 • Web-based Configuration Page 97