beautypg.com

Remote communication and control, Connecting a control device, See the – Extron Electronics SME 100 User Guide User Manual

Page 123

background image

Remote
Communication and
Control

This section provides information on:

Connecting a Control Device

Software Overview

Simple Instruction Set (SIS™) Control

Command and Response Table for SIS Commands

Power Save Mode

Connecting a Control Device

The SME 100 can be remotely controlled using one or more of the following methods.

Use a control PC or other device that is connected to the same network as the
SME 100.

Use a control PC or other device that is connected to the SME 100 using the rear panel
RS-232 connector (see the "

Rear Panel Features

" section on page 12).

Use a control PC or other device that is connected to the front panel Config port (see
the "

Front Panel Features

" section on page 11).

Remote communications are via SIS commands (see the "

Command and Response

Table for SIS Commands

" section on page 133). Use a communication utility, such

as DataViewer (see

"Downloading the software"

on page 118) or Telnet, to send

SIS commands and view the responses.

SME 100 • Remote Communication and Control

117