Extron Electronics SME 100 User Guide - Manual (Page 28)

Front Panel
Operation
This section details how to operate and configure the SME 100 using the front panel and
the menus available on the LCD display.
NOTES:
• For information on operating and configuring the SME 100 using the web-based
user interface, see the "
Web-based User Interface Operation " section on
page 46.
• For information on operating and configuring the SME 100 using SIS commands,
see the "
Remote Communication and Control " section on page 117.
This section provides information on:
• Overview of the Menus on the LCD Display
• Accessing the Menus on the LCD Display
• Presets Menu
• Input Config Menu
• Picture Control Menu
• Encoder Config Menu
• Stream Config Menu
• Advanced Config Menu
• Comm Settings Menu
• Using the Front Panel Lock (Executive Mode)
Overview of the Menus on the LCD Display
The SME 100 contains seven primary configuration menus and one hidden menu that are
displayed on the LCD display. Each primary menu contains a varying number of submenus.
The primary configuration menus are shown in figure 15. The primary menus and the
submenus are explained in more detail later in this section.
Menu
PRESETS
INPUT
CONFIG
PICTURE
CONTROL
ENCODER
CONFIG
STREAM
CONFIG
ADVANCED
CONFIG
VIEW COMM
SETTINGS
EDIT COMM
SETTINGS
Menu Menu Menu
Menu EXIT MENU?
PRESS NEXT
Menu Input 3
+
Next
Menu
Figure 15. SME 100 Primary Configuration Menus
NOTE: For information on accessing and using the hidden Edit Comm Settings
menu, see the " Edit Comm Settings Menu (Hidden) " section on page 43.
SME 100 • Front Panel Operation 22