Epson S1C33210 - Manual (Page 401)

III PERIPHERAL BLOCK: MONITORED MOBILE ACCESS INTERFACES
S1C33210 FUNCTION PART EPSON B-III-10-15
HDLC Communications Control and Operation
Transmit Control
(1) Enabling transmit operation
Setting the transmit enable (TXENS) bit in the HDLC command register (D6/0x0200308) to "1" enables
transmit operation, starting transmission from the start of the specified transmit queue using the HDLC clock
timing.
(2) Basic Procedure
Write the address, control, and data fields to the HDLC transmit data register (0x020031E).
The hardware automatically adds the CRC if the software writes "0" to the Tx underrun/EOM bit in the HDLC
transmit status register (D7/0x0200334) before a Tx underrun. Otherwise, the hardware skips the CRC (or
Abort) fields, sending the flag pattern immediately after the data field.
Specifying Abort with the CRC/Abort on underrun/EOM bit in the HDLC transmit operation settings register
(D1/0x0200318) replaces the CRC field with an abort pattern (eight "1" bits).
Zero insertion applies from the address through FCS (CRC) fields, but not to the abort pattern replacing the
CRC field.
(3) Ending transmit operation
To terminate transmit operation, write "1" to the send abort command bit in the HDLC transmit control register
(D[6]/0x020031C) to send an abort pattern (eight "1" bits) followed by the specified idle pattern, mark or flag.
The send abort command immediately terminates data transmission regardless of byte boundaries, sends the
abort pattern, and clears the queue.
Writing "1" to the clear transmit enable bit in the HDLC transfer release register (D6/0x020030A) to disable
transmit operation during a frame transmit operation also cancels transmit operation. The hardware
immediately terminates transmission of the current byte, shifts to the transmit operation disabled state, and
fixes the output at High level (mark state). Note that the queue data remains unchanged. Clearing it requires
writing "1" to the reset transmit queue command bit in the HDLC transmit control register (D5/0x020031C).
Either command immediately terminates data transmission regardless of byte boundaries.
(4) Transmit pattern for idle state
The output pattern is Mark (all "1") between a reset and an enable transmit command and after that command
depends on the setting in the Mark/Flag on idle (MRKFLG) bit in the HDLC transmit operation settings register
(D0/0x0200318).
Receive Control
(1) Enabling receive operation
Setting the receive enable (RXENS) bit in the HDLC transfer settings register (D7/0x0200308) to "1" enables
receive operation, including detection of flag and abort patterns.
(2) Basic Procedure
After initialization and the enable receive command, the receive block starts hunting for the flag pattern.
Detection of this pattern sets the Hunt bit in the HDLC E/S INT receive status register to "0" to indicate flag
synchronization.
To re-establish flag synchronization during the reception of a frame, write "1" to the enter hunt mode bit in the
HDLC receive control register (D1/0x020032C) to immediately terminate the receive operation regardless of
byte boundaries, cancel flag synchronization, and restart the hunt for the flag pattern.
Note that the receive queue remains unchanged. Clearing it requires writing "1" to the reset receive queue
command bit in the HDLC receive control register (D2/0x0200314).
Receiving an abort pattern (seven or more "1" bits) either during or after a frame receive operation also cancels
flag synchronization and restarts hunting for the flag pattern.
The hardware stores all data between the opening and closing flag patterns in the receive queue.
(3) Establishing Receive Address
If the byte immediately following the opening flag pattern establishing flag synchronization is not a closing
flag pattern, it is processed as the address field.