HEIDENHAIN TNC 306 Technical Manual - Manual (Page 7)

2-4
TNC 416/TNC 406/TNC 306 Technical data TNC 416/TNC 406/TNC 306 3/2000
TNC 416/TNC 406 TNC 306
Operating modes
• Manual
• Electronic handwheel
• Jog positioning
• Positioning with MDI
• Program run, single block
• Program run, full sequence
• Programming and editing
• Test run (logical and graphical)
Program input
• In HEIDENHAIN plain language format
• Manually on keyboard
• Externally over data interface
Input resolution
1 µm
display resolution
0,1 µm 1 µm
Programmable functions
• Nominal position (absolute or incremental) in Cartesian or polar
coordinates
• Linear path in 3 out of 4 axes
• Circular path in 2 out of 4 axes
• Helical path with simultaneous C-axis motion
• Corner rounding, chamfer
• Tangential contour approach and departure
• Tool number and length, radius compensation, tool undersize
• Spindle speed for axis C
• Rapid traverse
• Feed rate
• Insertion of programs into other programs
• Subprograms and program section repeats
• Fixed cycles: disk pocket, EDM polishing, tool definition,
generator definition
• Datum shift, coordinate system rotation, mirror image, scaling
• Dwell time, miscellaneous functions M, program stop
⋅
• Remote control via LSV2 protocol (only TNC 416/406)