HEIDENHAIN TNC 306 Technical Manual - Manual (Page 13)

2-10
TNC 416/TNC 406/TNC 306 Software 3/2000
Software version Release date Software version Release date
TNC 306 TNC 306
260 03x-03 2/92 260 05x-03 2/92
260 03x-04 3/93 260 05x-04 3/93
260 03x-05 8/93 260 05x-05 8/93
260 03x-06 11/93 260 05x-06 11/93
260 03x-07 3/94 260 05x-07 3/94
260 03x-08 6/94 260 05x-08 6/94
260 03x-09 6/94 260 05x-09 6/94
260 03x-10 11/94 260 05x-10 11/94
260 03x-11 2/95 260 05x-11 2/95
260 03x-12 6/95 260 05x-12 6/95
260 03x-13 11/95 260 05x-13 11/95
260 03x-14 2/96 260 05x-14 2/96
260 03x-15 11/96 260 05x-15 11/96
260 03x-16 1/97 260 05x-16 1/97
3.2 PLC Software
The PLC software is produced by the machine manufacturer. Either HEIDENHAIN or the machine
manufacturer can store this software in EPROMs. HEIDENHAIN assigns PLC software numbers to
the machine manufacturers on request. HEIDENHAIN can archive the specific PLC programs in a
database, so that the installation of the correct PLC program is assured if a control has to be
exchanged.