beautypg.com

Status window, 1 positional and status display, 3 status window – HEIDENHAIN TNC 306 Technical Manual User Manual

Page 180

background image


4-80

TNC 406/TNC 306

6 Display and operation 4

3/97

6.3 Status window

In the operating modes "Program run/single block", "Program run/full sequence", "Programming and
Editing" and "Test Run" the status information (position values, current tool, feed rate, eroding
functions etc.) are all displayed in the bottom half of the screen. In "Manual Operation" or "Electronic
Handwheel" mode the status information occupies the whole screen.

6.3.1 Positional and status display

The entry and display step for the HEIDENHAIN-contouring control TNC406/TNC 306 is 0.001 mm or
0.001°.

The most recently selected axis is displayed inversely. The PLC is informed (by a marker) which axis
has an inverse display. This information can be evaluated, for example, in connection with hand-
control equipment.

Set

Reset

M2096

X Key last pressed

NC

NC

M2097

Y Key last pressed

M2098

Z Key last pressed

M2099

IV Key last pressed

M2095

1)

V Key last pressed

1)

only TNC 406

This manual is related to the following products: