HEIDENHAIN TNC 306 Technical Manual - Manual (Page 385)

3/2000
TNC 416/TNC 406/TNC 306 Commands 7-95
3.12.4 Call Module (CM) CM
Abbreviation for PLC Editor: CM (CALL MODULE)
Jump processed Jump not processed
Execution time [µs] 5.0 ----
Number of bytes 22
Special Library Call:
Execution time [µs]
6.2 ----
Number of bytes 24
Operands: jump address (LBL)
Operation:
A Call Module instructs the processor to leave the main program and process the Module
designated by the jump address (LBL). Modules are independent subprograms and are terminated
by the command EM. They can also be called at multiple points in the main program. This command
interrupts a logic sequence.
3.12.5 Call Module if Logic Accumulator = 1 (CMT) CMT
Abbreviation for PLC Editor: CMT (CALL MODULE IF TRUE)
Jump processed Jump not processed
Execution time [µs] 6.8 to 7.2 1.0 to 1.4
Number of bytes 26 (24)
Special Library Call:
Execution time [µs]
7.4 1.4
Number of bytes 28
Byte information in brackets:
A shorter command is employed in certain high-priority program sequences.
Operands: jump address (LBL)
Operation:
A CMT command is a conditional Call Module. If the Logic Accumulator is "1", the Module with the
specified jump address (Label) is processed. If the Logic Accumulator is "0", the main program
continues without a Call Module. This command interrupts a logic sequence.
3.12.6 Call Module if Logic Accumulator = 0 (CMF) CMF
Abbreviation for PLC Editor: CMF (CALL MODULE IF FALSE)
Jump processed Jump not processed
Execution time [µs] 6.8 to 7.2 1.0 to 1.4
Number of bytes 26 (24)
Special Library Call:
Execution time [µs]
7.4 1.4
Number of bytes 28