HEIDENHAIN TNC 306 Technical Manual - Manual (Page 292)

7-2
TNC 416/TNC 406/TNC 306 PLC-functions 3/2000
3.1.9 ASSIGN WORD (W=) W= 7-35
3.1.10 ASSIGN DOUBLEWORD (D=) D= 7-35
3.1.11 ASSIGN NOT (=N) 7-36
3.1.12 ASSIGN TWO'S COMPLEMENT (= -) 7-36
3.2 Set-commands 7-38
3.2.1 SET (S) S 7-38
3.2.2 RESET (R) R 7-39
3.2.3 SET NOT (SN) SN 7-40
3.2.4 RESET NOT (RN) RN 7-41
3.3 Logic Gates 7-43
3.3.1 AND (A) A 7-43
3.3.2 AND NOT (AN) A N 7-45
3.3.3 OR (O) 7-47
3.3.4 OR NOT (ON) 7-49
3.3.5 EXCLUSIVE OR (XO) 7-51
3.3.6 EXCLUSIVE OR NOT (XON) XON 7-53
3.4 Arithmetic commands 7-56
3.4.1 ADDITION (+) + 7-56
3.4.2 SUBTRACTION (–) – 7-57
3.4.3 MULTIPLICATION (x) x 7-58
3.4.4 DIVISION (/) / 7-59
3.4.5 REMAINDER (MOD) MOD 7-60
3.5 Comparisons 7-62
3.5.1 EQUAL TO (==) == 7-62
3.5.2 LESS THAN (<) < 7-63
3.5.3 GREATER THAN (>) > 7-64
3.5.4 LESS THAN OR EQUAL TO (<=) <= 7-65
3.5.5 GREATER THAN OR EQUAL TO (>=) 7-66
3.5.6 UNEQUAL (<>) < > 7-67
3.6 Parentheses with logical gating 7-69
3.6.1 AND [ ] (A[ ]) A[ ] 7-69
3.6.2 AND NOT [ ] (AN[ ]) AN[ ] 7-69
3.6.3 OR [ ] (O[ ]) O[ ] 7-69
3.6.4 OR NOT [ ] (ON[ ]) ON[ ] 7-69
3.6.5 EXCLUSIVE OR [ ] (XO[ ]) XO[ ] 7-70
3.6.6 EXCLUSIVE OR NOT [ ] (XON[ ]) XON[ ] 7-70
3.7 Parentheses with arithmetic commands 7-73
3.7.1 ADDITION [ ] (+[ ]) + [ ] 7-73
3.7.2 SUBTRACTION [ ] (–[ ]) – [ ] 7-73
3.7.3 MULTIPLICATION [ ] (x[ ]) X [ ] 7-73
3.7.4 DIVISION [ ] (/[ ]) / [ ] 7-73
3.7.5 REMAINDER [ ] (MOD[ ]) MOD [ ] 7-74
3.7.6 INCREMENT (INC) 7-76
3.7.7 DECREMENT (DEC) 7-76