HEIDENHAIN TNC 306 Technical Manual - Manual (Page 289)

6–12
TNC416/TNC 406/TNC 306 List of Bytes, Words and Double Words 3/2000
Word Function Transmission Page
W692 Two-times gap 2G* E-table → PLC 4-63
W694 Minimum undersize UNS* E-table → PLC 4-63
B696 Auxiliary parameter 1 AUX1* E-table → PLC 4-63
B697 Auxiliary parameter 2 AUX2* E-table → PLC 4-63
B698 Auxiliary parameter 3 AUX3* E-table → PLC 4-63
B699 Auxiliary parameter 4 AUX4* E-table → PLC 4-63
W700 Auxiliary parameter 5 AUX5* E-table → PLC 4-63
W702 Auxiliary parameter 6 AUX6* E-table → PLC 4-63
B703 -
B747 Bytes reserved for eroding table —
W748 Free rotation of a second angular axis
If the 5th axis has also been defined as angle axis (A or B), you
can switch on the free rotation of this axis (behavior is similar
to ROT-C) by loading the PLC ouble word D748 with the speed
value (e.g. 10 000 for 10 rpm). By loading a negative value you
can reverse the direction of rotation.
An M function as with ROT-C is not required. —
W750
Reserved —
W752 Speed of a non-controlled rotary axis (M03, M04) PLC
→ NC
4-54
W756 Retraction distance for eroding timer PLC
→ NC
4-62
W760 First byte to transmit via RS-422/V.11 PLC
→ NC
4-70
W762 Number of bytes to transmit via RS-422/V.11 PLC
→ NC
4-70
W764 Spindle override factor in % PLC
→ NC
4-54
W766 Feed rate override factor in % PLC
→ NC
4-54
D768
to
D956 Value from MP4210.0 to MP4210.47 NC
→ PLC
7-14
W960
to
W974 Value from MP4220.0 to MP4220.7 NC
→ PLC
7-16
W976
to
W1006 Value from MP4310.0 to MP4310.15 NC
→ PLC
7-16
W1008
to
W1022 Value from MP4320.0 to MP4320.7 NC
→ PLC
7-16
W1024 Axis releases, bit-coded (5/4/Z/Y/X) NC
→ PLC
W1026 Axes in position, bit-coded (5/4/Z/Y/X) NC
→ PLC
W1028 Reserved -
W1030 Traverse direction, bit-coded (5/4/Z/Y/X) 0 = positive; 1 =
negative
W1032 Reference marks not yet traversed, bit-coded (5/4/Z/Y/X) NC
→ PLC