beautypg.com

HEIDENHAIN TNC 306 Technical Manual User Manual

Page 264

background image


5-16

TNC 416/TNC 406/TNC 306

List of machine parameters

3/2000

Machine
parameter

Function and input

Change
via

Reaction

Page

MP2120

Arc detection
(electrode retraction time)
Entry range: 1 to 99.9 [s]

123

4-60

MP2130

Maximum speed for feed forward control during
erosion
Entry range: 0 to 500 [mm/min]

4-56

MP2131

Feed rate limit to switch to new eroding feed rate
from MP 2132
Entry range: 0 to 500 [mm/min]

4-57

MP2132

New eroding feed rate when value from MP 2131
exceeded
Entry range: 0 to 500 [mm/min]

4-57

MP2133

Retraction speed during short circuit detected at
connector X12
Entry range: 0 to 500 [mm/min]

4-59

MP2141

Free-run feed rate if analog input is greater than
threshold from W520 (MP2081)
Entry range: 0 to 3000 [mm/min]

MP2142

Erosion feed rate (MP2081=1)
Forward: F = MP2142 * SV [%]
Backward: F = MP2142 * SV [%] * W522 [Factor]
Entry range: 0 to 3000 [mm/min]

MP2190

Constant-speed positioning during flushing
Entry values: 0, 1, 2

0 =

Electrode braked between each block

1 =

If the path is geometrically continuous,
the electrode moves at constant speed

2 =

Electrode moves at constant speed even
if the path is non-continuous

Removed in TNC 406 as of software 280 620-07

123

MP2199

Erosion table on/off
Entry values: 0 or 2
0 =

Tables not active

2 =

Tables active

4-62

This manual is related to the following products: